Custom manufactured flight simulator hardwareComplete turnkey solutions and individual items

Flight Simulator Hardware

Custom manufactured in USA.

dual linked flight controls 1

This unit is built using actual Boeing columns and wheels, and is designed for a 8 inch under floor space.  Control loading is static, and is pull tested to actual aircraft…

dual linked rudder pedals 737

Dual linked rudders are built using actual Boeing pedals, and are designed for repeated or high cycle use.  They have separate toe brakes on each pedal which can be set…

Throttle Quadrant 1

Completely refurbished. Moving throttles with DC motor and slip-clutch system. Servo-controlled Auto speed brake deployment. Motorized trim wheels. Servo controlled trim indicators. All wiring is pre-done, run to the front…

12'dia5'tall180degrees-a

This is a seamless, theater quality projection screen custom built to fit each individual project’s size requirements.  The most common size (pictured on the left and center above) is a 12 foot…

Tiller Assembly

    This Nose Wheel Tiller assembly was designed to fit directly into our 737 structure.  The assembly includes the 737 tiller handle, static control loading, and a slider pot…

floor structure

The Floor Structure is constructed of tubular aluminum, and comes in three bolt-together sections.  As an option it can be covered with 3/16” aluminum plate primed and painted, or with ¼”…

structure1

Construction The structure is made of steel and has a total weight of about 120 lbs. It is designed to fit into the shell or can be used as a…

737 pedal skids

These Rudder Pedal Skids and Covers are made from aluminum and are designed to be screwed to an existing floor.  As an option they could be built using ABS plastic…

slide windows

            These slider windows are accurate replicas of 737 slide windows, and will fit in a real nose section if you happen to be using…

headrests

Headrests are an add-on piece and are equipped with screw-on mounts.  They are available with or without embroidery. NG style Headrests $250.00 (set of 2) With embroidery $400.00 (set of…

compass

The Compass Holder is available with or without the compass.  It is also an exact replica of the standby compass used in the 737, and can be used with a real…

seat rails

These rails are designed to allow Webber 727/737 bolt down seats or Ipeco seats to move up to 6″ sideways.  This helps to facilitate entry past a 3 space pedestal…

Northern Flight Sim custom manufactures a range of Flight Simulator hardware. We use actual aircraft parts in our designs for dual-linked flight controls and rudder pedals. Intended for the hobbyist, our hardware is built to standards that will survive pro use in a training environment. All products depicted on this site are for simulator use only.
Contact Us